Switch to full style
Using the Stage CL
Post a reply

Boot to JANDS Splash Screen and Stops

Sun Nov 19, 2017 10:17 am

I was handed this console to setup control of some lighting and snow machines for Christmas. However when I turn on the console it just boots to the splash screen and does not continue. If I hold down the RECORD button when booting it displays SHUTDOWN COMPLETE after a few seconds.

Since its not booting I'm guessing that it is a software corruption problem. Is there a way to flash software if it is not booting in the first place?

Thanks for any help you can provide! Dwight (aka Teamfrisky)

Re: Boot to JANDS Splash Screen and Stops

Mon Nov 27, 2017 10:29 am

Teamfrisky wrote:I was handed this console to setup control of some lighting and snow machines for Christmas. However when I turn on the console it just boots to the splash screen and does not continue. If I hold down the RECORD button when booting it displays SHUTDOWN COMPLETE after a few seconds.

Since its not booting I'm guessing that it is a software corruption problem. Is there a way to flash software if it is not booting in the first place?

Thanks for any help you can provide! Dwight (aka Teamfrisky)

It's likely this console will need to be returned for service. Please complete a Stage CL support request form and be sure to quote the console serial number (found on the base of the unit).
http://jands.com/support-stage-cl/suppo ... -stage-cl/
Post a reply