Jands Lighting
https://jands.com/forum/

Boot to JANDS Splash Screen and Stops
https://jands.com/forum/viewtopic.php?f=31&t=4426
Page 1 of 1

Author:  Teamfrisky [ Sun Nov 19, 2017 10:17 am ]
Post subject:  Boot to JANDS Splash Screen and Stops

I was handed this console to setup control of some lighting and snow machines for Christmas. However when I turn on the console it just boots to the splash screen and does not continue. If I hold down the RECORD button when booting it displays SHUTDOWN COMPLETE after a few seconds.

Since its not booting I'm guessing that it is a software corruption problem. Is there a way to flash software if it is not booting in the first place?

Thanks for any help you can provide! Dwight (aka Teamfrisky)

Author:  davidm [ Mon Nov 27, 2017 10:29 am ]
Post subject:  Re: Boot to JANDS Splash Screen and Stops

Teamfrisky wrote:
I was handed this console to setup control of some lighting and snow machines for Christmas. However when I turn on the console it just boots to the splash screen and does not continue. If I hold down the RECORD button when booting it displays SHUTDOWN COMPLETE after a few seconds.

Since its not booting I'm guessing that it is a software corruption problem. Is there a way to flash software if it is not booting in the first place?

Thanks for any help you can provide! Dwight (aka Teamfrisky)

It's likely this console will need to be returned for service. Please complete a Stage CL support request form and be sure to quote the console serial number (found on the base of the unit).
http://jands.com/support-stage-cl/suppo ... -stage-cl/

Page 1 of 1 All times are UTC + 10 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/